Eagle USB
From blag.wiki.aktivix.org
Contents |
Intro
The Eagle USB DSL modem packages work with the Eagle 8051 Analog modems, such as the Sagem F@st 800.
Install
To check if the packages are installed on your system run:
rpm -q eagle kernel-usb-eagle
If they are not installed, you can install them by running as root:
apt-get update apt-get install eagle kernel-usb-eagle depmod -a
Or, since you may not be on the 'net yet...you can install them from CDROM:
mount /dev/cdrom /mnt/cdrom cd /mnt/cdrom/BLAG/RPMS rpm -Uvh eagle-* kernel-usb-eagle-* depmod -a
(Note the package may be renamed kernel-module-usb-eagle in the future.)
Then plug in your modem. To see how it faired, run:
dmesg
Or look in the logfile: /var/log/messages. If you really want to find out lots of info about it, run:
/usr/sbin/lshw
Load driver into kernel
To load the driver into your kernel run as root:
/sbin/modprobe eagle-usb
Configuration
The configuration files are:
/etc/eagle-usb/eagle-usb.conf
You should make a backup of this file before you edit it, in case you want to revert to the original
cp -p /etc/eagle-usb/eagle-usb.conf /etc/eagle-usb/eagle-usb.conf-dist
You will need to make changes to these lines:
#POTS FOR EAGLE OPTN0=80020066
The OPTNO will need to be changed to the telephone number (guess).
VPI=00000008 VCI=00000023
VPI and VCI need to be changed to values given to you by the Internet Service Provider.
You may need to change the encapsulation:
#The following values are valid for encapsulation : #MPOA_MODE_BRIDGED_ETH_LLC ----> 1 #MPOA_MODE_BRIDGED_ETH_VC ----> 2 #MPOA_MODE_ROUTED_IP_LLC ----> 3 #MPOA_MODE_ROUTED_IP_VC ----> 4 #MPOA_MODE_PPPOA_LLC ----> 5 #MPOA_MODE_PPPOA_VC ----> 6 Encapsulation=00000006
You don't need to change anything if your Internet Service Provider is using PPP over ATM. If they are using a different encapsulation, you'll have to change the values. Translation:
1 = Bridged Ethernet LLC 2 = Bridged Ethernet Virtual Circuit 3 = Routed IP LLC 4 = Routed IP Virtual Circuit 5 = PPP over ATM LLC 6 = PPP over ATM Virtual Circuit
You probably don't need to change other values in the file.
Documentation
Documentation files are in:
/usr/share/doc/eagle-VERSION
Where version is the version you are running such as eagle-1.9.6
Firmware
There are two firmware files:
/usr/share/misc/dsp_code_isdn.bin /usr/share/misc/dsp_code_pots.bin
If needed you'll probably need the second one, unless you know you are on ISDN (not very common).
Links
http://sl33p3r.free.fr/linux.html http://www.eagle-usb.org
